| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
05-28-2004, 05:55 PM
|
||||
|
||||
Is it possible to run a small mig welder on a short (12') 12-3 extension cord?
Thanks Randy |
|
#2
05-28-2004, 05:55 PM
|
||||
|
||||
|
Is it possible to run a small mig welder on a short (12') 12-3 extension cord?
Thanks Randy |
|
#3
05-28-2004, 06:18 PM
|
||||
|
||||
|
12 gauge wire is rated for 20 amps, so as long as your welder draws less than that you should be OK. You're not going to get any appreciable voltage drop over ten feet.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
