| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-26-2005, 02:42 PM
|
|||
|
|||
Adapting Fan Shroud from a 64 Catalina
Is it possible to adapt a full-size metal fan shroud from a 63-64 389 Catalina to a 65 GTO 389 tri-power? I have not found any discussion in the forums that addresses this issue.
|
|
#2
10-26-2005, 06:45 PM
|
||||
|
||||
|
I've seen it done, and I don't think it is that hard a job, but I forget exactly what the differences are.
|
|
#3
10-29-2005, 10:47 PM
|
||||
|
||||
|
I am interested in that swap too as I have a full sized steel shroud somewhere. LOL!
Tom V. I think it would require making templates of the "A" body shroud and then comparing them to the fullsize part. Tom V.
__________________
"Engineers do stuff for reasons" Tom Vaught Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward. |
|
#4
10-30-2005, 08:36 PM
|
||||
|
||||
|
On my last aquisition. I got the correct fan shroud with it, that was not installed. I'll take some pics, and make some measurements.
After that we can compare to the full size and figure out what is needed to be cut etc. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
