| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-18-2008, 01:17 PM
|
|||
|
|||
Correct gaskets and exhaust hangers
What is the correct gasket for a stock 64 gto exhaust pipe to manifold flange. Would it be the compressed round "doughnut" type or is it a flat metalized type gasket.
Also were can I get new rear tail pipe hangers. The ones that bolt to the outside of the rear frame rails? Thanks, Brian |
|
#2
07-18-2008, 04:54 PM
|
||||
|
||||
|
No gasket or donut needed at the manifold to pipe connection. The bottom of the manifold is shaped so it fits into the bell of the down pipe. The rear brackets are available from our host - RPE648 1964-72 TAILPIPE HANGERS......................................$13.0 0/pr
Correct OEM hangers for all Tempest, LeMans & GTO exc. 1964-65 w/ splitters,
__________________
More pictures of my former Goat: http://www.barrett-jackson.com/appli.../w_search.aspx My old car is listed in the 2007 Scottsdale Auction, Lot #1016 - $60K And in the 2008 Scottsdale auction, Lot #960 - $80K Eventually sold by Brighton Motor Sports in Scottsdale, AZ -$89,900 |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
