[importsmasher]

I have a 73 Ventura 2-door hatchback body shell for sale. The body shell is the same as a 74 GTO. It is a stripped shell with no front subframe, no rear axle, and no interior. It has both doors and is rust free except for some bubbles behind the rear wheels and a small spot in the trunk. It has a rust free tail panel and floors. I have a clear Arizona title in my name. I will sell it all for $500 or I will cut it up for parts. Let me know what you need. I do have some leftover Ventura parts that I will sell also, such as a passenger fender (needs work but no rust), driver side fender patch ("heel" behind the wheel), rear interior panels, quarter and rear glass, front bumper, brake/clutch pedals (not sure of origin, but they were in this car for 15 years), A/C parts (under dash stuff), assorted seat belts, and random interior and trim parts.

Thanks,
Importsmasher

[importsmasher]

right rear frame rail and driver front floor gone....$250 for all or part of the remaining shell (other parts extra).

[importsmasher]

Still available...

[importsmasher]

Bump

[Rob B]

Sent you a pm.

[importsmasher]

Still here....

[importsmasher]

bump

[importsmasher]

bump

[importsmasher]

bump

[importsmasher]

bump

[importsmasher]

bump

[johnkmoon]

Need a front bumper impact strip for a 74 GTO, would you have one?

[importsmasher]

I don't, sorry. My parts car is a 73 which uses a different bumper, and the front bumper doesn't have a rub strip anyway.

Importsmasher

[johnkmoon]

Thanks for the reply

[rem-1187]

would you be willing to cut out the rear tail panel if so how much shipped to delaware 19734 also looking for black door panels . Walt

[importsmasher]

Yes, I can cut out the rear tail panel, it would be $250 plus shipping. I can't get an exact shipping cost until it's cut off (which I am not willing to do until I have a commitment to purchase), but I can get an estimate. Shipping will probably have to be Greyhound (unless you know of other shipping options), as it will be too big for UPS or the post office. If you let me know the nearest bus station I can get an estimate of shipping cost. Where would you want it cut? If you give me an email address, I can send you more pictures of the tail panel.

Thanks,
Importsmasher

[rem-1187]

`im interested , i replaced one many years ago it seams to me there are several spot welds that hold it to the fenders and trunk . should be able to drill them out . short of that a saws all or plasma cutter will work. just cut it out wide , this will ruin the fenders. please do email me some photos w.sweetman@yahoo.com

thanks Walt

[importsmasher]

Email sent. Let me know if you don't get it.

Thanks,
Importsmasher

[importsmasher]

bump

[importsmasher]

I will entertain any reasonable offer...