| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
 |
|
Menu
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
| The Body Shop TECH General questions that don't fit in any other forum |
| Reply |
|
|
Thread Tools | Display Modes |
|
#1
11-22-2025, 02:50 AM
|
|||
|
|||
Bumper reveal for front bumper 1966 2+2
Installed my front bumper today. Going through my manuals I don't see any measurement for how much reveal I should leave below body line on the side of the front fender. I have looked at several photos; some are really tight to an inch or so below. What I had before was quite low. So, I can't go by what it was before I took it off.
|
|
#2
11-22-2025, 09:08 PM
|
||||
|
||||
|
I'd say about half of that
__________________
The difference between inlaws and outlaws? Outlaws are wanted |
|
#3
11-23-2025, 12:25 AM
|
|||
|
|||
|
Thanks Steve. I was looking at some old brochures, and they look pretty tight. I'm thinking i am going to set it at 1/4 of an inch. I realize it's not a photo, but the rendering is consistent throughout the brochure.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
