Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.14 seconds. Search: Posts Made By: HWYSTR455
Forum: EFI Tech Yesterday, 07:42 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Looking at the 'Meth Twin Turbo' global file...

Looking at the 'Meth Twin Turbo' global file example under 'Custom Cals' > 'Racing', the approach above sounds about right:

This is the AFR table for that global file.

.
Forum: EFI Tech Yesterday, 07:38 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
You mentioned E85, so this may be of some...

You mentioned E85, so this may be of some interest to you:

"The stoichiometric air fuel ratio of gasoline ranges from approximately 14.5 to 15.0 but is generally considered to be 14.7....
Forum: EFI Tech Yesterday, 07:04 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Ok, went back and re-read, you're running the MSD...

Ok, went back and re-read, you're running the MSD dual sync.

It is extremely important to make sure you have the inductive delay set properly. As RPMs rise, like over 3000-4000 RPM, the timing can...
Forum: EFI Tech Yesterday, 06:53 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Not sure if that's a vacuum port or not, but you...

Not sure if that's a vacuum port or not, but you could pull the body and blast a little air in it, see where it comes out (or not).

I would think you would want something larger than a fuel line...
Forum: Pontiac - Street Yesterday, 07:15 AM
Replies: 19
Views: 469
Posted By HWYSTR455
The programmable 6-AL2 supports 1, 2, or 3 bar...

The programmable 6-AL2 supports 1, 2, or 3 bar MAP sensor. Look at the YouTube vid I posted. It's easy to used, you have a graph that you can drag points to your desired values.

The MSD 6-BTM is...
Forum: Pontiac - Street 06-15-2024, 09:24 AM
Replies: 19
Views: 469
Posted By HWYSTR455
Here's the dowload location for the MSD Pro Data...

Here's the dowload location for the MSD Pro Data software, you can play with it before you buy if you want:

https://www.holley.com/support/resources/#Software_Downloads

.
Forum: Pontiac - Street 06-15-2024, 09:18 AM
Replies: 19
Views: 469
Posted By HWYSTR455
I was hardcore Jacobs in the 80s & 90s, but...

I was hardcore Jacobs in the 80s & 90s, but eventually moved on as my boxes died. Totally believed in the approach, 'Multiple Spark Discharge' tech is flawed.

But that was then, this is now, and...
Forum: EFI Tech 06-15-2024, 08:04 AM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Cool, replied to other thread, and sure, will...

Cool, replied to other thread, and sure, will take a look, PM me to start a new PM-chain and will give you my email.


.
Forum: EFI Tech 06-15-2024, 08:03 AM
Replies: 96
Views: 10,517
Posted By HWYSTR455
Yeah sure, shoot me the files, I can take a look....

Yeah sure, shoot me the files, I can take a look. PM me to start a new PM chain.

.
Forum: EFI Tech 06-14-2024, 12:19 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Which remote IAC are you using? And you did...

Which remote IAC are you using?

And you did a TPS Autoset after?

How much timing at idle and vacuum do you have?

Do you have timing control?

.
Forum: EFI Tech 06-14-2024, 12:19 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Which remote IAC are you using? And you did...

Which remote IAC are you using?

And you did a TPS Autoset after?

How much timing at idle and vacuum do you have?

.
Forum: EFI Tech 06-14-2024, 07:53 AM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Start with the base calibration file...

Start with the base calibration file 'TBI_Stealth_4150_8Inj_454ci' and go from there.

Since it's a Stealth, you don't need a cam sync, you can lockout a pro billet or use a hyperspark (hall...
Forum: EFI Tech 06-14-2024, 07:49 AM
Replies: 31
Views: 1,926
Posted By HWYSTR455
You have to do a TPS Autoset after adjusting the...

You have to do a TPS Autoset after adjusting the plates.


.
Forum: EFI Tech 06-14-2024, 07:48 AM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Many times, just like a carb, you need to crack...

Many times, just like a carb, you need to crack the throttle plates some. You want the IAC to work at below @10%, adjusting the plates will get you there.


.
Forum: Pontiac - Street 06-14-2024, 07:20 AM
Replies: 20
Views: 513
Posted By HWYSTR455
The US Shift controller is certainly...

The US Shift controller is certainly full-featured, and I recommend it often. IMO it's the go-to in many situations.

My first 4L80e conversion I ran a CompuShift, that too was pretty...
Forum: 70-72 GTO Tempest & LeMans TECH 06-13-2024, 03:06 PM
Replies: 6
Views: 314
Posted By HWYSTR455
Is it supposed to REPLACE or is it just a cover...

Is it supposed to REPLACE or is it just a cover like a dash cap?

Wonder how the headlight buckets will mount?

No instructions included, no comments on how to install, no reviews, not a very...
Forum: Pontiac - Street 06-13-2024, 01:16 PM
Replies: 20
Views: 513
Posted By HWYSTR455
So I have my converter unlock at <3% TPS, so I...

So I have my converter unlock at <3% TPS, so I can coast when I lift. That you don't want to have on all the time. When you're in anything but OD, you get full engine braking the way I have it setup....
Forum: EFI Tech 06-13-2024, 12:57 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Back to original questions: Unless you have...

Back to original questions:

Unless you have other restrictions, an in-tank pump using a properly baffled tank is best. The in-tank pump assemblies can support big power. There are even dual pump...
Forum: EFI Tech 06-13-2024, 12:57 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Back to original questions: Unless you have...

Back to original questions:

Unless you have other restrictions, an in-tank pump using a properly baffled tank is best. The in-tank pump assemblies can support big power. There are even dual pump...
Forum: EFI Tech 06-13-2024, 12:42 PM
Replies: 31
Views: 1,926
Posted By HWYSTR455
Ok, just to clarify, the 'Terminator X', and...

Ok, just to clarify, the 'Terminator X', and 'Terminator X Max' are ECUs, and are replacing the HP and Dominator ECUs.

The difference between the 'Terminator X' and the Terminator X Max' is the...
Forum: Pontiac - Street 06-13-2024, 08:34 AM
Replies: 11
Views: 410
Posted By HWYSTR455
I knew to run mineral based oil, but I checked...

I knew to run mineral based oil, but I checked the box for oil when I ordered it, it was the Lucas 85w mineral based one, not the syn.

Mine's sloppy, clunks when I put it in gear, and whines when...
Forum: Pontiac - Street 06-13-2024, 08:25 AM
Replies: 42
Views: 1,184
Posted By HWYSTR455
Moroso breathers are pretty good, and don't get...

Moroso breathers are pretty good, and don't get much mist. They are kind of larger, have a divider in them, as well as some 'mesh' (which looks like a cut up 3M pad stuff).

The Billet Specialties...
Forum: Pontiac - Street 06-13-2024, 08:04 AM
Replies: 12
Views: 397
Posted By HWYSTR455
Yeah, MAD sometimes can make you mad. But you can...

Yeah, MAD sometimes can make you mad. But you can use a lot of it as a basis to do your own setup.

I do the remote sol setup on all my stuff, for a couple reasons, but mainly so the starter wire...
Forum: Pontiac - Street 06-13-2024, 07:46 AM
Replies: 20
Views: 513
Posted By HWYSTR455
I get that at the strip you can make it optimum,...

I get that at the strip you can make it optimum, but you can't switch tunes on the fly, you have to cycle the key, at least on Holley EFI setups.

Now US Shift is a diff story.

Going from street...
Forum: Pontiac - Street 06-12-2024, 03:57 PM
Replies: 20
Views: 513
Posted By HWYSTR455
I still shift my manually in some 'spirited'...

I still shift my manually in some 'spirited' moments, my WOT shift points are set a little lower for general driving, and sometimes I want to hold a gear a little longer.

But yes, I do shift it...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 02:27 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017