[HWYSTR455]

Only way to make that OE work is to have someone TIG a build up on top of the runners and re-port. Not cost effective.

The RPM intake will work, you can get one from Butler to match very good if you have them work it. They know the exact dimensions of the ports since they did them, and can mod an intake easily.

If they milled the heads, they should know that info too.

If the heads are straight out of the box, you still need to have the intake checked, many times they don't fit properly and require at least a little work.

My understanding is there's a backlog on Edelbrock intakes, so, might want to prepare to wait.

.