Trunk Lid Support?
 

I recently installed my rear spoiler and now that lid is rather heavy. I understand that the Judges came with a support to hold it open. Are these available anywhere?

They did not come with a support to hold the trun lid open. In '69 both torsion rods were thicker to counter the added weight. In '70 one thicker torsion rod was installed.

I do not know of anywhere you can get repros of these rods. The best you can do is to adjust your rods to the furthest notch to add torsion to them.

I measure several rods for 69s & found NO difference.
The rods must be in the middle & the closest to the bumper slots. my deck stays up in 50 MPH winds

I agree with Sweet i have messured a few agains my Judge and never found them to be any different, its all in the positioning in of the rods in the three adjustment slots. Years ago i put a auto trunk release on my GTO and when i was done and hit the button the deck lid tried to fly off the car! just needed to adjust the rods for a little less tension. Same is true of adding a spoiler only the rods have to be adjusted the other direction.

any idea where i can get a 69 hardtop spoiler??
[email protected]

Have you tried our host?
#RPR60 $229

YES, they are different, when looking at them alone they may not sppear different but put them side by side and it becomes obvious. I sold a pair on Ebay for 350.

If I remeber correctly one of the pair was 3/16", I can not remember if the Judge was that size or non Judge.

i have an extra set of rods & spoiler. BUT I HAVE FOUND NO DIFFERENCE