Rodney Butler's complete clutch and bellhousing
 

Hays 2 disk, aluminum hat and flywheel. New fingers, inserts, disks (5135), floater. Has one race on it since fresh (Norkwalk last year 6.27). Comes with 3 sets of springs, spare fingers, disks and floaters. Lots of shims, weights, etc. Same clutch Arnie runs in the Tameless Tiger and Bag Boys Grocery Getter. $700.

Lakewood steel 8 1/8 bellhousing. Liner, cross shaft, candlestick, and throwout bearing. Pontiac and Chevy pattern. $700

$1300 for both. This would cost you $5000 new! This combo will work well for a mid 6 to 8 sec car.

Also have an Autometer 34 channel data logger with drive shaft, vac sensor, accelerameter. $500

Call Rodney Butler 866-762-7527

Nice to see you join up. Hopefully you'll have time to hang out a little...

Rodney,
Glad to see you on the PY board. Many if not all will value your input and contributions.

If you have time we all would like to hear a bit more about the last year of test and tunes for your record setting hot rod.

See you soon,
Jim

agreed with the other fella's, glad to see someone from the Butler Crew join up! I was glad to work with you fellas on my stroker build. engine's running great! :thumbup:

:focus: good luck with the sale.

Sup Rodney

bump. good deal for someone

Will the bellhousing work with a small cased CS-3 Lenco Trans?

Has Lenco and B&J pattern

is the bellhousing still available?