Vinyl top molding
 

Can anyone help me out with how many spring clips are used for the molding? Got a kit from Ames which has 6 rail clips and 6 spring clips. I have 8 spring clip holes on each side. Not much help when I asked tech at Ames. And do the v shaped moldings only use the spring clips?

Thanks

Four clips each side. Two screws front one, one each next three so those can pivot.

http://forums.maxperformanceinc.com/...1&d=1520582183

Three spring clips for each V moulding, one outboard, two inboard. You can see the 1/4" holes if you look closely at the two pictures.

http://forums.maxperformanceinc.com/...1&d=1520582183

Hey thanks for you help...so looks like no spring clips for straight molding based on you pic? I have those 1/4" holes down the sides as well as for the v shaped molding.

Another pic

I don't have the small holes for the screws...not sure if body man filled them in. Does your car have the 1/4" holes along the side?

No sir, just the small screw holes. Mine was a KC car, where was yours built?

Those may have been drilled out to be able to use the spring clips instead of the snap on clips??

Mine is a CA car. It sure looks like these are original holes, been so lone since I tore down car I don't remember how they were attached. Tried to get Ames to sell me more spring clips separate but I have to buy another kit. Have to find the remaining clips elsewhere.

FWIW...my 67 is also a Ca. car and it did not have the metal "clips" shown in Old Goat 67's photos. I assume the clips I used are the spring clips you are referring to. I don't remember how many there were but I did have to get more than came with the kit from Ames.

Thanks to both of you for your input...you solved my dilemma...going to order more of the spring clips and go with it.. 👍