473 Cu.In. Engine for Sale
 

473 cu.in. intake to pan. Add a Carb and distributor and start it up.
*400 block
*Eagle 6.8" H-beam rods
*Ross Pistons
*Eagle 4.25 stroke crank
*10.5 to 1 compression
*Edelbrock Round Ports (310cfm)
*Comp Cams Hydraulic Roller (.550 lift. I
don't have the other specs on the cam)
*Victor manifold, has been cut apart to
port the runners
*Canton Oil pan
*Super Duty oil pump
Listing for a friend, engine runs great, was in a driver with A/C. Approx 9,000 miles on it. Was only removed to replace with a 500" motor. I will get some cleaner pics this weekend.
$6,500

Location?

Also interested in knowing location

Sorry...
Location is Largo FL.
Also, has Harland Sharp 1.65 Roller Rocker arms

Any power numbers or times?

So for any power estimates I can only relay this...
The engine was in a full interior 70 GTO with AC. We raced from a 2nd gear roll a couple times. My car is a Firebird, ran low 10s at 130 at the time. I was a little faster but not a blow out.

If anyone wants the owners info just PM me and I will get it to you.

I spoke with the owner, he did have the car at the track 1 time for a grudge race. Here is a picture of the car off the starting line. It was an 1/8th mile track, ran 7.05 in the 1/8th, he doesn't remember the mph. Wallace calculators put the power level tight at 600hp based on the ET.

Very nice engine, it'd probably cost triple to duplicate it in today's market.


GLWS

Sold .. thanks