Quote:
Originally Posted by gtofreek
Then I ground a groove in the lifter bore to lower the oil hole for hydraulic roller lifters. You can see the line I scribed 1/4" below the oil hole. This is where I grind down to.
|
What is this going to do? Will it lower your oil pressure? Could the groove be made in the lifter body rather then the block?
Rich
__________________
68 Firebird 400, #16, xe274, street dominator, 850 DP, hooker headers, t400, 3500 stall, 3.73, 295/65 bfg drag radicals... best 13.27 @ 102.8, 1.90 60ft
|