[HWYSTR455]

Couple things to note:

The Moser housing center casting is stronger than a OEM 12 bolt.

Moser uses beefy caps.

Moser's powder coating is not cheap, just spray if with epoxy or engine enamel.

The Dynalite brake setup is basically for drag, and there are much better disc setups for less money. Just order the rear 1" narrowed on each side and use a different disc setup. (Like the one from Kore3).

If you're doing a Moser, add the 7900FM housing ends, you will be light years ahead.

With that said, I've had a few Moser 12 bolts. I recently ordered one, and sadly, the setup was sloppy, and the backlash allows the axle back & forth slop about an 1/16 of a turn. Not happy. Sure, they will fix it, but I would have to send it back.

That could have just been a fluke, everything I've ever gotten from them is spot-on, so...

I will be posting on my build thread an update that includes my Kore3 disc setup.

One thing that urks me about ordering from Moser is the fact that the invoice has no build info on it. I have to call them, ask them to give me the build info, and take notes. (Invoice attached)


.