| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
11-03-2004, 11:31 AM
|
|||
|
|||
I installed the carpet on my '67 and in the quarter door panel area, glued and ran the carpet up about an inch. As I get ready to install the rear door panel, there's a flap of vinyl at the bottom, about 1 1/2" wide, which looks like it wants glued to the floor. Which means the carpet would need trimmed to the panel as opposed to being behind it like I have it now.
Is this correct to trim the carpet this way? |
|
#2
11-03-2004, 11:31 AM
|
|||
|
|||
|
I installed the carpet on my '67 and in the quarter door panel area, glued and ran the carpet up about an inch. As I get ready to install the rear door panel, there's a flap of vinyl at the bottom, about 1 1/2" wide, which looks like it wants glued to the floor. Which means the carpet would need trimmed to the panel as opposed to being behind it like I have it now.
Is this correct to trim the carpet this way? |
|
#3
11-03-2004, 03:29 PM
|
||||
|
||||
|
The vinyl flap goes back up behind the side panel, not glued to the floor. Leave a little extra carpet like you have done.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
