| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
12-15-2004, 09:37 PM
|
|||
|
|||
I have a '65 GTO clone with a Pontiac 400 engine and it had only water in it and the temp went below freezing a popped the front freeze plug on the drivers side....I can reach the area, how difficult is it to replace and any suggestions. Thanks
|
|
#2
12-15-2004, 09:37 PM
|
|||
|
|||
|
I have a '65 GTO clone with a Pontiac 400 engine and it had only water in it and the temp went below freezing a popped the front freeze plug on the drivers side....I can reach the area, how difficult is it to replace and any suggestions. Thanks
|
|
#3
12-16-2004, 12:47 PM
|
|||
|
|||
|
not difficult if old one is out. Get new one, green locktite, and evenly hammer it in place.
|
|
#4
12-16-2004, 04:13 PM
|
|||
|
|||
|
FYI: They arent freeze plugs they are core plugs. They are there to get the sand out of the block, heads, Etc. from the casting process. Dont depend on them to keep your block from cracking if it freezes.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
