| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
07-14-2004, 07:54 PM
|
|||
|
|||
My top is giving me some problems. The motor seems to work ok but the top hardly moves. Could I have a leak in the pump or lines?
Thank you, Matt |
|
#2
07-14-2004, 07:54 PM
|
|||
|
|||
|
My top is giving me some problems. The motor seems to work ok but the top hardly moves. Could I have a leak in the pump or lines?
Thank you, Matt |
|
#3
07-15-2004, 06:33 PM
|
||||
|
||||
|
does the motor struggle when you try to put it up , or does it operate smoothly? if it is struggling , either the lift cylinders are gummed up and need replacing , or the top is out of alignment. you can check the alignment by disconnecting the cylinders and operating the top by hand to check for binding in the arms. take a look for air in the lines also , this could be from a leak or bad seals allowing air to enter. on the end of the lift motor there is a rubber plug about 1" in diameter. this is how the system is filled and bled. be careful removing the plug because it is about 1 1/2 inches long and could be brittle. the fluid should be 1/4" below the opening.
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
