 |
|
| Non Pontiac Motors in Pontiacs includes factory 403,305,350 Chevy, Buick V6, Also Pontiac Motors in non-Pontiacs! |
|
|
Thread Tools | Display Modes |
|
#11
05-05-2011, 08:57 PM
|
||||
|
||||
Also, mine is 3.5" steel. If you do an aluminum, I would have it sized smaller in the last 12" or so if you can, because mine wants to hit right at the back of the back seat tray, right where the rear seat bottom catch is in a hard bump like right on the bumpstops. The stock driveshafts were stepped in the back this way. Again, 70 may be different. I did not do aluminum because usually you have to go a size bigger in aluminum to keep the strength and I knew I did not want any more clearance issues.
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode