[blueghoast]

Well I ended up modifing a set of a-body pedals which was very easy to do.
I had to straighten the bends in them to get them over to the left side a
little more so I could move the gas pedel also. I just cut the sheet metal
that the gas pedal was mounted to and move the hole section over and
welded it back in place. The master cly. I took that and moved it up to the
next set of bolts above the original mounting place and opened up the hole
were it went inside the fire wall. Theres two holes in the brake pedal were
the linkage attatches the rod to the master cly. It's almost as if the factory
new I was going to do this modification and my cluch peadal linkage has a
bend in it so I can poke a hole in the fire wall just next to the sterring
colume and that will be inside of the inner fender well, I'm modifing a z-bar
so it will set in the stock location also. I can't believe how easy this is
comming together after I just stood back and thought about it a little bit.



GT.