| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-11-2014, 01:57 PM
|
|||
|
|||
Temp sender in Edelbrock head?
Greetings, I'm getting ready to install the Edelbrock E-street EFI on my '79 T/A and I have a question. I'm running E-heads and the RPM manifold and I currently have the temp gauge sending unit in one of the threaded holes and the heater core hose in the other hole in the cross-over.
I intend to use the current temp sender location for the sender to the EFI ECU. That leaves me no place for my gauge sending unit. Any reason I couldn't install the gauge sending unit in one of the rear holes where the heater hose would normally go? I know, I could just move the heater hose to the head but I like it where it is as I feel it promotes more even cooling as the coolant from both banks flows rear to front before it exits to the radiator. Thanks, Gary |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode