[twinturrbo406]

... i would like to thank everyone involved in this build, but most importantly Dick Fulton, for allowing me the opportunity to show what these heads can do, and I'm very thankful for that ...
... we made 1095hp @ 8000 and 757 ft.lbs @ 7100 rpm, with good power past the peaks, we ran the engine well over 8k most of the day and pulled to 8500rpm several times and the engine never blinked, we did have some minor leaks that kept the vacuum to around 6 inches at the peak, so we believe 1120hp is in hand once the vacuum issue is resolved, but the torque curve was extremely flat and I'm sure once this baby gets a sniff of the funny stuff it's going to make some big power ...

... Dick's engine is a purpose built 13 to 1 N20 Combo, so we obviously are excited to get some compression n/a versions together using the CV330/Raceplate heads and Roland Racing's CNC ported cast tunnel ram which was used on this engine, and while we have high hopes for the even larger development ports (CV345, CV365, CV385) we can't wait to see what some compression will do using the same top end as Fulton's ...