| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-19-2015, 12:28 PM
|
||||
|
||||
Trans Swap question
Ok guys, possibly stupid question here, but before I go and start removing things I would like some input.
I have swapped out my TH 400 for a 200-4R. It is a little narrower that the TH400, so the linkage from the trans up to the steering column now hits my headers, and I cannot move the shifter through it's full range of motion. I have toyed with the idea of removing this linkage, but I know it is tied into the neutral safety switch on the column. If I remove this linkage, and anchor the column arm, what will happen? I am also looking at lengthening the rod that goes from the trans to the frame so that I can retain all of this linkage. Any 200-4R swap guys here? What did you do?
__________________
461 Cu. In. Pure Pontiac Power: 1969 Pontiac GTO - Back On Top - Popular Hot Rodding Magazine |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode