| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#26
11-08-2017, 11:06 PM
|
||||
|
||||
Agreed. Press fit is holding power. Preferred methods will vary. Mine is 0.015" per inch of bore. Which would be 0.006" press for a 389/400. Sleeve spends a few hours in the freezer, and installed when the block is still warm from over-bore operation. Brake fluid is used as anti-gall lubricant. Then add notch accordingly.
|
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode