| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#20
04-30-2025, 03:41 PM
|
||||
|
||||
The early non SD standard production forged rods are not of a grade of steel where applying a heat treating process is going to gain you much for the effort and then the money involved in resizing them.
1140 steel is like the average hardware store 8”” adjustable wrench . BTDT! I would much sooner polish them , lighten them at the pin end and then spend money on cryo treating them without the new rod bolts in, then load in the new bolts and check & resize as needed.
__________________
Wernher Von Braun warned before his retirement from NASA back in 1972, that the next world war would be against the ETs! And he was not talking about 1/8 or 1/4 mile ETs! 1) 1940s 100% silver 4 cup tea server set. Two dry rotted 14 x 10 Micky Thompson slicks. 1) un-mailed in gift coupon from a 1972 box of corn flakes. Two pairs of brown leather flip flops, never seen more then 2 mph. Education is what your left with once you forget things! Last edited by steve25; 04-30-2025 at 03:49 PM. |
| The Following User Says Thank You to steve25 For This Useful Post: | ||
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode