[fyrffytr1]

Originally Posted by ksgto

I have a 67 h/h shifter and in the restoration book it calls for two washers under the front mount. On mine it looks like it needs a bushing to keep it up for the cable not to be in a bind to be able to shift. Thanks for any info Bob

You must have read my mind! I was just about to post this same question. I only have two of the thick washers. Are the thin washers fiber or metal. Do they go under the mount or between the bolt and mount?

[kate`s67gto]

Fiber washers seat to floor then the thin washer with shifter sitting on the washers with the bolt securing . The thin washers only show at center tunnel top attaching points. I used a steel washer.