| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
08-22-2009, 02:01 PM
|
|||
|
|||
While researching 7027273 I ran across this posting. Those problems with your original carb can be repaired.
|
|
#2
08-22-2009, 06:30 PM
|
||||
|
||||
|
I took the card to a local shop that has been rebuilding carbs for 20+ years and he wasn't too optimistic. However, he did not have any parts available to fix the affected areas either.
Can you recommend a good rebuilder? |
|
#3
08-22-2009, 08:07 PM
|
|||
|
|||
|
I have some spare quad parts let me look tomorrow & I'll post what I find tomorrow night.
|
|
#4
08-22-2009, 11:45 PM
|
|||
|
|||
|
Try and post a picture of the bad inlet and maybe one of our members can give advice. I have a '67 carb where the inlet is very thin and my carb guy says he can still salvage it. The broken throttle shaft is a minor problem unless it's rusted into the base plate. Even then I know a guy who can remove it. Is your carb a Rochester or Carter?
Robert [email protected] |
|
#5
08-23-2009, 07:05 PM
|
|||
|
|||
|
Both of the carbs I have side inlet's.
|
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
