| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
|
|
#1
03-03-2011, 06:43 PM
|
||||
|
||||
Can the steering wheel itself be rotated on A-bodies or does the horn mechanism only allow a single position? If so, perhaps it's off by a couple splines?
Mine is off a touch as well - I was hoping to be able to address it in this manner when I change the ignition cylinder in the spring...
__________________
Kevin's Homepage 1970 Pontiac GTO Orbit Orange Judge Re-creation / YZ RAIII 400 / M21 4-Speed 1985 Chevrolet Monte Carlo SS 5.7 LITRE / TES Headers / SShaker Hood / WCT5 5-Speed |
|
#2
03-03-2011, 09:54 PM
|
||||
|
||||
|
Sometimes the alignment will take out the mis-alignment with the steering wheel....otherwise you can remove one of the teeth on the lock plate and re-orient it on the steering shaft.
|
|
#3
03-03-2011, 10:16 PM
|
||||
|
||||
|
I agree with PMDRACER. I did this on my GT-37. It takes a little time but it is not difficult.
|
|
#4
03-04-2011, 01:17 AM
|
||||
|
||||
|
The adjusters for the tie rods sleeves are the answer but recommend that, after the adjustment, you still have the front end aligned. If not aligned better than by eyesight, can scrub tread off front tires.
My two cents. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
