[GT182]

There's only one gasket that goes on after the 2 divider plates are installed and before the pump is installed.

I thought at one time there must be a gasket between the divider plates, but that is not so. They might have been thinking that.

Good luck and let us know how it's doing.

[67cruiser]

Thank You very much, i thought so, it went together without any problems. One more question, any differance between a air con. fan blades and standard ones?? I had a flex fan on my motor and switched back to clutch fan but blades are within 1/8 of hitting shroud????

[GT182]

Not sure but I think the a/c fans are 7 blade and bigger in diameter..... 19-1/2"s?

I've got a 6 blade fan with clutch on mine, and have about an inch clearance to the shroud.... non a/c. Looks to be around 17-1/2"s in diameter. Can't get an accutate measurement tho.... going by catalogs on diameter.

[67cruiser]

Yes it measures 19.5 and it go,s all the way around without hitting anything, the clutch and fan, hoping ill be safe

[GT182]

If you're not running a/c and you get nervous about the 1/8" clearance, go to the 6 blade fan with the smaller diameter.

[67cruiser]

Not nervous, excited to see what happens, hope it cools alot better,tuned my stainless divider plates down to about .060 ill know soon!