[Pzr]

The block is already bored .030 over (Some badger pistons was in it)
I have block and water pump ass, and the old crank (do not have numbers on that).
I need heads, crank (Maby?), camshaft, lifters, intake manifold, carburator etc.

I have been looking at e-heads... and think roller lifters would be good.. (or not?)

Now i need a path to go so I know what stuff to get.

My main goal is a strong street engine that I can rely on. Using pump gas. And maby try to go 402m with. :-) An engine I can grow with if you know what I mean.

Meanwhile I use my 68 350 H.O.

Any recommendations?

Hmm ya. I have 3.42 in the rear and stock converter to the th350 and runs RA manifolds and a dual 2.5'' exhaust from pypes.