[PurelyGTO68]

Originally Posted by Vol

One more question about the radiator filler rubber on the bottom of the core support.
I read the post http://forums.maxperformanceinc.com/...ghlight=filler but there were no photos of how it is installed. In this post there are few shots, but I am trying to figure out what type of fastner holds it on? I looked online at AMES and eBay but my search terms did not even find the rubber.

The rubber seal is secured with 4 metal retaining clips that are sorta T shaped.
Here are some photos of a core support that I pulled from a LeMans (V8 A/C car) On this example, the seal is also secured on the LH side with the same bolt used to fasten the lower LH radiator mount. Hope these photos help...

[Vol]

Originally Posted by PurelyGTO68

The rubber seal is secured with 4 metal retaining clips that are sorta T shaped.
Here are some photos of a core support that I pulled from a LeMans (V8 A/C car) On this example, the seal is also secured on the LH side with the same bolt used to fasten the lower LH radiator mount. Hope these photos help...

Those are perfect. I have the seal, and it only goes in one way from what I can tell. There are some flat indents in the rubber where a fastener went so I figured it must be a T-bolt of some sort. Thanks for sharing.

Now I need to dig through all my parts buckets to see if I have those fasteners or find something close that will work. Since this build is not an original I am not concerned.