 |
|
| Pontiac - Boost Turbo, supercharged, Nitrous, EFI & other Power Adders discussed here. |
| Reply |
|
|
Thread Tools | Display Modes |
|
|
|
#1
08-14-2016, 10:26 PM
|
||||
|
||||
In my opinion I would mill the intake before using epoxy. You would have to go pretty far into the ports to straighten them out and I'd be afraid of it coming loose. Splash zone is a good epoxy that people use for this kind of stuff. I've used it before. It's good stuff, but it was $75 for the two parts years ago. BES in Sunman Indiana milled my intake for $120.
If it helps we milled .120" from my Victor to get it to sit right. My block has been milled too. |
| Reply |
| Thread Tools | |
| Display Modes | |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Hybrid Mode
