[gassman_67]

does anyone know how to replace the rear trunk brace (the ones the gas tank straps slide into)???

[gassman_67]

update! no longer using the multi trunk panels, after removing all the storesd parts from the interior, I've discovered the front trunk panel brace that is at the joint where the floor panel meets...is no longer there.
I have been looking to purchase the Dynacorn 1584WT.
Has anyone here used one? does it have to be modified at the tail panel? I have the rear body mounts off, and was planning to slip it in above the frame from underneath. I have the bumper off and can see what I think is the trunk floor under the tail light panel. Where do I remove the old floor at the tail panel?

[gassman_67]

2 more questions...sorry, can I use a plasma cutter to remove the old trunk safely near the frame/wheel wells, as far as I understand the ground is to the trunk only, so it should not burn through the rails????
Secondly, at the tail panel, to remove the back section of the pan can I just remove the spot welds from tail to pan, or do I have to remove the tail panel also?

Thanks!
Happy Easter