[gtorich]

Originally Posted by 78w72

Whats wrong with the current cover? Unless its damaged or has heavy corrosion pitting, save some $$ and clean it up to reuse it. Probably doesnt need to be glass beaded either, just clean/degrease/scuff it up to repaint. Can also use normal blaster media at low psi further away without any problems too, new shop should have a blaster.

Hey Scott, happy thanksgiving, im not sure of the condition of this one, i have a small chip on bottom, dont think thats any problem, have some heli-coils in there also, getting the paint off seems to be the biggest problem so far.

What do you think, roll the dice and use it

Rich

[78w72]

Originally Posted by gtorich

Hey Scott, happy thanksgiving, im not sure of the condition of this one, i have a small chip on bottom, dont think thats any problem, have some heli-coils in there also, getting the paint off seems to be the biggest problem so far.

What do you think, roll the dice and use it

Rich

Thanks, Hope you had a good T-day too!

That cover looks to be in pretty good shape compared to some others Ive seen... Helicoils arent a problem, actually stronger than the original aluminum threads. The paint should come off with a blaster or even a chemical stripper at home... or if its still in good shape and mot flaking, scuff it up & paint over it. I would clean it up and reuse it for sure.

The gasket surface doesnt look too bad, have seen a lot worse from corrosion and they seal up fine when using a thin bead or a good RTV, can also fill any pits with JB weld as mentioned but that doesnt look bad at all, RTV with the gaskets should be fine, (thin bead smoothed with your finger on both sides of gasket)