| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
04-20-2003, 11:55 AM
|
|||
|
|||
Hello, I can't figure out how I did it, but I warped the passenger side flange on my Doug's headers. I took them off and put them on a flat surface. It appears that only the end flange for the exhaust port near the firewall is affected. Is there anyway to correct this? I was thinking about cutting the middle of the flange at that end so that it would pull it down when I tightened it. Any suggestions? Thanks, Gary
|
|
#2
04-20-2003, 11:55 AM
|
|||
|
|||
|
Hello, I can't figure out how I did it, but I warped the passenger side flange on my Doug's headers. I took them off and put them on a flat surface. It appears that only the end flange for the exhaust port near the firewall is affected. Is there anyway to correct this? I was thinking about cutting the middle of the flange at that end so that it would pull it down when I tightened it. Any suggestions? Thanks, Gary
|
|
#3
04-21-2003, 08:53 AM
|
||||
|
||||
|
My advice, call Doug's Headers and ask for Paul. 909-788-4878.
Ron 
__________________
Due to the current economic conditions...the light at the end of the tunnel has been turned off. Meet you at the finish line.....don't be late! |
|
#4
04-23-2003, 12:36 AM
|
|||
|
|||
|
Thanks Ron, Paul at Doug's Headers seemed OK with cutting the flange, and after asking around it seems to be a routine fix for this problem...Gary
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
