| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
05-07-2007, 11:11 PM
|
|||
|
|||
seperating trans from rearend?
trying to remove the autotrans section from rearend for just jay. The torque tube had 6 bolts removed torque tube Then removed cap on torque conv. removed wire ring removed conv. Then removed 4 bolts holding aluminum part to rear section. Now it is loose rotationally but wont seperate before trying force? clip or something im missing? thanks Rod
|
|
#2
05-08-2007, 01:46 AM
|
||||
|
||||
|
Cant remember if you have to remove the speedo drive or the governor?? 1 or both have to come out. The tech manual is not real clear on this. After much reading through 3 different tech manuals, pull the governor out of the trans!!
Last edited by mechanickeith; 05-08-2007 at 02:27 AM. |
|
#3
05-08-2007, 08:37 AM
|
||||
|
||||
|
Try Ken at East West Auto, He will know 1-800-447-2886
Thanks for trying Rod. |
|
#4
05-08-2007, 09:51 PM
|
|||
|
|||
|
seperating
thanks mechanickieth removing the govener allowed it to slide right apart no force nessecary. thanks again. Rod
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
