| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
06-22-2010, 09:16 PM
|
||||
|
||||
Wiring Harness Wrapping Details ?
Can anyone link me to some info on the correct way to rewrap a wiring harness?
|
|
#2
06-27-2010, 07:53 AM
|
|||
|
|||
|
You need the proper tape , start at the bulkhead connector about 2" in , go to the connector then go away from it , this way you do not have a loose end , at the 1st. intersection of wires wrap the intersection , then pull the roll of tape up to the farthest end away, and start to wrap there back to the intersection . It will be 1 continuous piece of tape until the end . When at the end tie a knot , pretty simple .
|
|
#3
06-27-2010, 08:51 AM
|
||||
|
||||
|
Thanks Chrisp,
Figured it out by looking at the old harness wrap really closely. Did it last week with the proper non-sticky tape and it came out extremely good! Charles |
|
#4
06-28-2010, 06:07 PM
|
||||
|
||||
|
Where did you get the non sticky tape?
__________________
Its ok to giggle and snicker, Dont laugh and point |
|
#5
06-28-2010, 06:13 PM
|
||||
|
||||
|
|
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
