[Jim Robertson]

In post #4 and #388 I show a mock up of a Victor intake on the pro ports on an IAII block. The bolt holes line up nicely. Thus the reason we tried to keep our ports within the casting of the Victor. The BOP will also "fit" between the heads and bolt holes will line up (depending on the bolt hole option you get from Wade). When attempting to test fit the Tiger intake to these heads, the Tiger runners are longer resulting in a different flange position. Basically the Tiger intake fits the Tiger heads. We found about .750" will need to be removed from Pro ports, Tiger intake or a combination of both. Since the Pro ports have a massive flange we chose to mill most of the difference from the there. The flange on the Tiger intake is approximately .450" thick so removing .200" or so is no big deal. We studied both the BOP and the Tiger intakes and for this set we chose the Tiger.