[71lemans71]

I have a ton of spider cracks all over my front bumper any way I can fix it


Sent from my iPad using Tapatalk

[niceta]

There is some good posts on here about how to restore a front endura rubber bumpers. From what I have read you need to V-grind out all the cracks and use a 2 part flexable filler to fill and finish the bumper with. I am using Dominian sure seal flexable bumper repair which is a 2 part epoxy filler that sands very nicely. Then from what I have read you should not use filler or polyester type primer. You should use epoxy primer. This is my first attempt but here are some pics of what I have done so far. The Dominian sure seal stuff is flexable. I have tried to push on the bumper after a couple coats and it has not cracked if that means anything. I am going to let it sit for awile to see if it stays flexable before priming.

[niceta]

Here is a pic of the bumper before grinding out spider cracks. These cracks were the same when the paint was still on.

[niceta]

forgot to upload. here ya go

[Greg Reid]

Originally Posted by 71lemans71

I have a ton of spider cracks all over my front bumper any way I can fix it.

Have you removed the paint and primer yet? Just wondering as it's hard to tell what's cracked until you get all the coating off.
I used the 3m flexible bumper repair stuff. You can get it at Advance, etc.
As was said above, there are a LOT of posts here on refinishing endura bumpers.