| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-24-2016, 07:09 AM
|
||||
|
||||
Routing Wire To The Door For PW/PDL
Does anyone have a pic if the hole locations for a door jamb wire loom on a 2nd gen Firebird? I have some wire looms as seen in the pic to install for getting wires to the door for windows and locks. There's a dimple that suggests 'Drill Here' but is that correct and then where to punch through the door. Thanks for the help.
__________________
There are no problems..only solutions. |
|
#2
08-24-2016, 11:49 AM
|
|||
|
|||
|
Here are some pics of a rusted out 75 TA.
https://www.dropbox.com/s/5z4hye3trb...e%201.JPG?dl=0 https://www.dropbox.com/s/hg8teornz4...e%202.JPG?dl=0 https://www.dropbox.com/s/7jamhcat5a...e%203.JPG?dl=0 I don't think the wiring loom you have is the correct one. It's different from the ones I have and I've seen for these cars. Here is a link to E-Bay with one that I think is correct. http://www.ebay.com/itm/70-81-CAMARO...BXUZED&vxp=mtr 
|
|
#3
08-24-2016, 11:17 PM
|
||||
|
||||
|
Thanks for posting the pics. Agreed what I have is not correct but this project is not going for originality. That said, those holes are massive. I can see the knockout on door on mine but had no idea the factory punched a 3" hole to route a few wires.
__________________
There are no problems..only solutions. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
