| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
08-24-2016, 02:37 PM
|
|||
|
|||
Muncie 4 speed question
I'm getting ready to rebuild a Muncie M20. My question is which way does the oil slinger belong on the input gear? Does the raised center of the slinger disk face toward the front or rear direction. Some guys use an additional shim as well to gain better 4th gear engagement. Would the shim go in front or in back of the slinger? Thanks for advise!!
|
|
#2
08-24-2016, 05:24 PM
|
|||
|
|||
|
The slinger, dont really know if it makes much difference which way it goes. The shim goes between the slinger and the bearing, so it pushes the gear back about .030"
__________________
1968 Firebird 400 RAII M21, 3.31 12 bolt, Mayfair Maize. 1977 Trans Am W72 400, TH350, 3.23 T Top Everyone you will ever meet knows something you don't. Bill Nye. |
|
#3
08-24-2016, 06:02 PM
|
||||
|
||||
|
I had the same question in my mind when I rebuilt mine a short time ago.... One direction it will slightly rub the outer bearing race if I remember right I put it on the other way so the outer part of the slinger is towards the rear... The slinger doesn't appear that it will do much either way..
__________________
........... The More You Follow The Herd The Less You Can Be In The Lead .......... Last edited by Formulas; 08-24-2016 at 06:08 PM. |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
