About Us

[email protected] · 09-20-2016, 02:24 PM

Paul I'm over here in Springfield
If you guys get a race set up I'll volunteer to hold the money

LOL

PAUL K · 09-20-2016, 02:31 PM

Quote:

Originally Posted by 535 tall deck

Paul I'm over here in Springfield
If you guys get a race set up I'll volunteer to hold the money

LOL

Thanks.... I hope things are better in your part of the state than up here.

Stan Weiss · 09-20-2016, 02:33 PM

Quote:

Originally Posted by PAUL K

Stan, have I said anything negative about anyone's car on this website?

Paul,
OK, I will ask it differently.

You have questioned the results from some builds that have been posted where "E" heads were replaced.

Have you ever posted questioning the results of Lil Jack's build?

Stan

slowbird · 09-20-2016, 02:33 PM

Quote:

Originally Posted by PAUL K

Thanks.... I hope things are better in your part of the state than up here.

Is there a good/better part of this state???

[email protected] · 09-20-2016, 02:48 PM

I wish...this whole state is worse than a Pontiac with a chevy engine

PAUL K · 04:00 PM

Quote:

Originally Posted by Stan Weiss

Paul,
OK, I will ask it differently.

You have questioned the results from some builds that have been posted where "E" heads were replaced.

Have you ever posted questioning the results of Lil Jack's build?

Stan

Stan, has there been a thread on PY with Jack's results?

Also, other than a thread that a gentleman was inquiring about his hi-ports not meeting his expectations can you tell me where I've questioned any E-head replacement threads?

PAUL K · 09-20-2016, 03:02 PM

Quote:

Originally Posted by slowbird

Is there a good/better part of this state???

Evidently no.....see 535 Tall Decks response.

PAUL K · 09-20-2016, 03:03 PM

Quote:

Originally Posted by Scott Roberts

Yeap.... Turbo car is fine long as it has doors.. Any tire and min weight or what?va

Yes it has doors. Is Mylan on October 7 a possibility for you guys?

Scott Roberts · 09-20-2016, 04:33 PM

Too far...find some thing halfway like Ohio...

BruceWilkie · 09-20-2016, 04:34 PM

Quote:

Originally Posted by 535 tall deck

I wish...this whole state is worse than a Pontiac with a chevy engine

That was my impression of Rantoul when I was stationed at Chanute 45yrs ago. There are worse places than Illinois though.

PAUL K · 09-20-2016, 04:58 PM

Quote:

Originally Posted by Scott Roberts

Too far...find some thing halfway like Ohio...

Maybe some other time.

[email protected] · 09-20-2016, 05:08 PM

Damn. 57 pages and no racin'

Good hustle Paul and Scott.

Scott Roberts · 09-20-2016, 05:22 PM

Quote:

Originally Posted by PAUL K

Maybe some other time.

Maybe... Its a long way for either of us to haul..

TimeWarp · 09-20-2016, 05:33 PM

Quote:

Originally Posted by 69Goat1

Gotta correct you a little bit... Poe had KRE HP heads and then switched to CV-1's...

Edit...

Yep...ooops! Same thought patern behind going faster though eh? lol

BruceWilkie · 09-20-2016, 06:27 PM

[QUOTE=PAUL K;5632409]

Quote:

Originally Posted by BruceWilkie

Not hatin' on you Paul but making remarks worded so you can later deny you meant anything "bad" by them is chicken ****. So is deflecting questions.

/QUOTE]

Would this be worse than making up the facts as you go along?

What question did I deflect?

Lets start here and get back to that^^^...

http://forums.maxperformanceinc.com/...postcount=1010

Quote:

Some people in this thread jump to conclusions.... also some perfer to make their own facts up.

I followed with...
http://forums.maxperformanceinc.com/...postcount=1013

Quote:

Who?? Name names so we know who you are talking about.

Before next reply to me paul posts this...
http://forums.maxperformanceinc.com/...postcount=1026

Quote:

TTB is very well versed in expected gains from increased power. All of his CV1 combos have made more power than their predecessor.

I respond to post 1026
http://forums.maxperformanceinc.com/...postcount=1034

Quote:

So who lost power over previous heads Paul? Do tell.

BTW you deserve a point of credit this time...at least you dropped a name.

Your response...
http://forums.maxperformanceinc.com/...postcount=1038

Quote:

Please reread my post....then explain what you are asking.

My reply...
http://forums.maxperformanceinc.com/...postcount=1091

Quote:

Re-read your own post. It implies Bill makes things up and his heads have not shown improvement over others previous heads.

My reply was simply asking you to point out where there hasnt been improvement.

I didnt ask you to deflect the question.

Not hatin' on you Paul but making remarks worded so you can later deny you meant anything "bad" by them is chicken ****. So is deflecting questions.

If you want to criticize Bills work show him how its done then.
Get a work piece, set and agree on targets, and find a neutral party to test against each others work.
Doesnt have to be a CV head...maybe someone has a damaged unported E-head (or other)that could be cut to be a work piece for both of you.

* I probably should have discussed this with Bill but I think he'd accept the challenge.

pauls reply.(note still no answer to the question in post 1034^^^)
http://forums.maxperformanceinc.com/...postcount=1092

Quote:

There you go jumping to conclusions and getting all butt hurt over your own words, again.

paul additionaly says...

http://forums.maxperformanceinc.com/...postcount=1099

[quote]

Quote:

Originally Posted by BruceWilkie

Not hatin' on you Paul but making remarks worded so you can later deny you meant anything "bad" by them is chicken ****. So is deflecting questions.

/QUOTE]

Would this be worse than making up the facts as you go along?

What question did I deflect?

For saying "you" I guess that means me...close enough to a name... you get another credit.
SO now im making up facts? Please share with everyone what "facts" I've made up! This should be interesting. Be sure to provide reference and dont forget any I acknowledge when I've got something wrong.

As to the questions you deflected... See posts 1013 1026 and 1034
The questions asked in those 3 posts.

All here in one post to save you from jumping page to page.

Seems like you're taking lessons from Gach and hoping you can cloud your posts till they get buried in new posts. Maybe he'll give you a good report card and a sticker.

cgeise · 09-20-2016, 06:34 PM

Here is a different way to ask the question -- Have the CV1 OR 2 lived up to the projections that you and others were screaming about 7 years ago - saying they are better than an e-head is a pretty low bar to jump over as it is a 20 year old casting and without a doubt really a design that was made for the street -- so, has it reached the potential that you stated or believed it would, just a question no hate or other wise.

BruceWilkie · 09-20-2016, 06:35 PM

What does racing a Buick and a Corvette have to do with how much HP someone can make a with Pontiac?

Scott Roberts · 09-20-2016, 06:40 PM

Quote:

Originally Posted by BruceWilkie

What does racing a Buick and a Corvette have to do with how much HP someone can make a with Pontiac?

Nothing but it could have been fun if we could have come together on a location and $.... I just saw where Paul said he was looking for a race with no takers and offered at potential race. Did we offend you Bruce?

PAUL K · 09-20-2016, 07:07 PM

Quote:

Originally Posted by Scott Roberts

Nothing but it could have been fun if we could have come together on a location and $.... I just saw where Paul said he was looking for a race with no takers and offered at potential race. Did we offend you Bruce?

They only want to race keyboards around here

PAUL K · 09-20-2016, 07:08 PM

Quote:

Originally Posted by BruceWilkie

What does racing a Buick and a Corvette have to do with how much HP someone can make a with Pontiac?

There you go jumping to conclusions again. It's a Camaro and Corvette.

Menu

About Us