| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
10-13-2018, 10:06 PM
|
|||
|
|||
68 GTO quarter window seal/trim
Hi all, first post here.
I have a 68 GTO that is getting a little face lift. The outside seal that goes between the quarter window and the exterior is shot. Attached photo for reference. I've looked through some of the restoration and re-pop sellers and can't find this piece. Does it come preshaped, or is it sold in a straight length and bent to fit the opening as needed? Is there a good guide on how to refit the new piece?  Thanks for any help. Ryan |
|
#2
10-14-2018, 09:44 AM
|
||||
|
||||
|
Ames ought have it. Only seen Pre-curved. Must insist on "Round" not "Flat" stainless bead for Quality and correctness.
Excellent result when you CAREFULLY feed the jagged tabs during install. Then perfect the curve by hand/mallet banging the shape to get the black rubber edge to flush up with body paint. Screw at each end assures excellence. |
|
#3
10-14-2018, 04:32 PM
|
||||
|
||||
|
Glass channel weatherstrip aka window fuzzies. F230B in the Ames catalog for the set. You definitely get what you pay for with the replacements.
https://secure.amesperf.com/qilan/De...part_num=F230B
__________________
Ken '68 GTO - 464 - Ram Air II heads - 236/242 roller - 9.5” TSP converter - Moser 3.55 Truetrac (build thread | walk around) '74 Ventura 350 '69 AMC Javelin SST |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
