[Stan Weiss]

Originally Posted by POS Racing

Just dynoed my 350P 2.0 build and cant wait to get it in the Ventura!

584.5hp/523tq on 93 octane

BUILD SPECS

,030 custom Autotec pistons
Eagle 6.625" H beam rods
Eagle 3.75" stroke cast crank
10.7 comp. Cranks 175lb

Custom solid roller cam
244/[email protected]"
.676/.670 lift
112LSA

KRE D-port heads bought bare as cast
Custom chamber and port work to maximize potential with the small 3.905 bores
2.055/1.625 valve also for best 3.905 bore power

Victor intake manifold with tapered spacer
(Fully ported Street Dominator produced a bit stronger curve below 5000 rpm but lower peak numbers...576hp/521tq)
950HP Holley carb
1 3/4 headers

Started this build with a goal of 575hp/525tq on pump gas and a 10 sec Ventura (NA) in street trim. 2 boxes checked! Cmon spring!

Very nice build.

Can you post the dyno sheet for the fully ported street Dominator? Depending on gearing and convertor it is possible that that setup might run faster in the 1/4 mile.

Stan