I'm going thru that conversion on my '64. Using stainless Inline Tube lines for '64, will have to fab 2 short lines up to the new MC. So far, have the 4 lines in from the firewall back; slight tweaking needed in a few spots.
Will have to fab 2 short new lines down from the new MC... and it looks like I have the wrong front crossmember line (catalog listed 'narrow' and 'wide' engine crossmembers (??), and apparently I chose wrong). May just fab that one, too.
I had a bigger issue with the hoses I also bought from them; the rear 'axle' hose was completely wrong- was male/female when it needed to be female/female.
|
05-01-2023, 04:39 PM
Threaded Mode