| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#1
09-07-2025, 01:26 PM
|
|||
|
|||
Mounting repro Ram Air hood pan
I am starting my 68 Firebird project and it came with some fiberglass ram air reproduction pieces. The car is a 400 4 speed but not a Ram Air.
The original hood is in very good condition and I really do not want to cut it up for some reproduction pieces that aren’t correct. Has anyone cut up a hood pan to where it will fit a factor hood with a few screws? I don’t need it correct but I do like the look of the Ram Air set up. Thanks in advance for any suggestions Jeremy |
|
#2
09-07-2025, 04:35 PM
|
|||
|
|||
|
Just try mounting it I had a steel pan on my car without cutting the hood.
|
|
#3
09-08-2025, 01:42 PM
|
|||
|
|||
|
Having had factory RA hoods before I can tell you that a 6 yr old can do a better job of hacking.
__________________
Everything comes and goes Pleasure moves on too early And trouble leaves too slow |
| Reply |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Linear Mode
