[CGMDD]

I was looking at a pair or two on ebay, and was wondering what a decent price to pay for a set would be? All seem to need slight repair.

[Cammer-6]

Is endura rubber printable using 3D printing or is it formed under high pressure?

['ol Pinion head]

Originally Posted by CGMDD

I was looking at a pair or two on ebay, and was wondering what a decent price to pay for a set would be? All seem to need slight repair.

On the '71-72 T-41 headlamp housings, Ive typically sold them two different ways bare OR w the headlamp buckets, springs, screw retainers, headlamp retaining rings.

Pricing... On the low end, bare & needing moderate fiberglass repair, $50 a piece on housings. Really nice shape, ready to scuff & prime, now up near $350 a side loaded out (no alum headlamp bezel).
Have quite a few used housings. '71's & '72's are mainly what I do. Have owned both NOS T-41 housings & NOS headlamp bezels. NOS headlamp bezels are near extinct, been tough for last 25 years.
Very nice used reconditioned headlamp bezels that have been polished & re anodized are typically the only resort for high end show builds, for nice "driver local showcar" type builds pitted bezels are best resort.