| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#2
09-02-2023, 04:05 PM
|
||||
|
||||
At only a -6 you may be asking for too much with e85. I only see Edelbrock making a -6 set. https://www.edelbrock.com/fuel-rail-...nish-3634.html
I have -8 Wilson’s rails on mine fed by dual 450’s. My end goal is around 1200hp as well. I suppose it’s possible Wilson’s may already have the measurements for a Pontiac and will make you a set of -8 rails. You’d have to ask them. My conversion was done by my chassis guy using Wilson’s parts. Wilson’s does the whole conversion with parts for around $950 https://www.wilsonmanifolds.com/page...on-conversions
__________________
James 1970 Trans Am Spotts Built 484" IA2, Highports, EFI Northwind, E85 Holley Terminator X sequential EFI fabrication and suspension by https://www.funkhouserracecars.com/ |
| The Following User Says Thank You to R 70 Judge For This Useful Post: | ||
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode