| FAQ |
| Members List |
| Social Groups |
| Calendar |
| Search |
| Today's Posts |
|
#29
01-28-2024, 02:05 PM
|
||||
|
||||
couple more
its hard to see but its almost as if the valve seat is a bit smaller than the actual bowl area. these are the 78cc 310 cnc heads. its a really small area about quarter inch long and its right where the seat wall meet. u can see where the maching stops and cast starts, its right in that area.
i was gonna get so.e 80 grit sanding rolls an just kinda clean up.the rest of the as cast area and try slightly blending that area in...but then i seen the epoxy i mentioned. what do you think |
|
|
The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.
Threaded Mode