[kingbuzzo]

Finally got this done with some mixed results;

- ordered the PUI ABS perforated black vinyl unit from Jeggs
- showed up in a box rolled up 😒
- let it sit long time on garage floor with some weight on it
- buddy came by yesterday and pulled old one out - cardbored
- took the new one out of the plastic and it had a f#%#% crease in it
- put torch to back of it and the crease is somewhat gone
- the glue they used is in weird pattern and the vinyl looks like it has tiger striped high spots all over it - sigh - huge pain to send it back from Canada - pressed on
- some of my side clips were worn out with no teeth so looking for those
- unit went in ok with some trimming required
- lining the up the sun visor screw holes was nitemare but finally done

So, no more saggy headliner but still doesn't look great. I don't think I'll buy from them again.

There are low spots on each the driver and passenger side because the ABS doesn't conform to the sloping roof line. Other than spashing some kind of glue in there I'm not sure what can be done because the ABS is flat yet the roof is not. Only the side clips and dome light holding her in.

Did you guys run into this?

Thanks