[1967Tempest]

Originally Posted by 1967Tempest

I asked him yesterday and he assured me that it was a TH350..

Thanks!!

Well, it looks like when I asked him to check and got the word yes, it meant I didnt look at all. Now it might be a TH200. Other than the tranny not holding up to 99 more cubic inches and the associated hp and tq, will it bolt up???

Thanks!!

Dave

[goatwgn]

Originally Posted by 1967Tempest

Well, it looks like when I asked him to check and got the word yes, it meant I didnt look at all. Now it might be a TH200. Other than the tranny not holding up to 99 more cubic inches and the associated hp and tq, will it bolt up???

Thanks!!

Dave

Yes, it will bolt up. You will have to hook up the TV cable to get it to work properly. Good luck.

[1967Tempest]

Originally Posted by goatwgn

Yes, it will bolt up. You will have to hook up the TV cable to get it to work properly. Good luck.

Or what?? It is a TH200. AS there is no vacuum modulator.

Actually this is going rather well.. A few setbacks, but not bad. The starter for the 301 will start a 301 and that is it. Upgraded to a regular 400 starter. Should have it running tomorrow...

Thanks again!!!

Dave

[goatwgn]

The TV cable on the TH200 should move about 1 and 1/8th inch from wide open throttle back to idle. It should be pulled out all the way at full throttle. Using the setup on the 301 as a guide should put you in the right ballpark. The TV (throttle valve)cable combines the functions of the Vacuum modulator and the downshift in one valve assembly.