Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.38 seconds. Search: Posts Made By: 78w72
Forum: 70-73 Firebird & TA TECH 06-20-2026, 09:59 AM
Replies: 11
Views: 636
Posted By 78w72
Rustoleum is a good quality spray can or crush on...

Rustoleum is a good quality spray can or crush on paint.... only issue is that it takes a lot longer to dry, like 2 hours to the touch & overnight to 24hrs to be fully cured. And it is always on the...
Forum: 70-73 Firebird & TA TECH 06-19-2026, 10:36 AM
Replies: 11
Views: 636
Posted By 78w72
If youre using a spray can... krylon satin is an...

If youre using a spray can... krylon satin is an excellent sheen & good quality paint, have used it on many parts under the hood etc, goes on smooth, dries fast & holds up to engine heat or debris...
Forum: THE LOBBY 06-13-2026, 09:51 AM
Replies: 13
Views: 793
Posted By 78w72
How about bringing back or fixing the notices to...

How about bringing back or fixing the notices to thread posts & PM's too? Would be nice to know when someone replies to new posts or questions or sends you a PM... & while were at it, allow tagging...
Forum: Pontiac - Street 06-10-2026, 09:59 AM
Replies: 11
Views: 624
Posted By 78w72
Next time your under the car you can look up at...

Next time your under the car you can look up at the rear of the pan and see if there's the OEM rubber prongs sticking out of the holes in the pan with no RTV... or remnants of cork gasket & RTV...
Forum: THE LOBBY 06-08-2026, 10:12 AM
Replies: 57
Views: 3,268
Posted By 78w72
Typo... supposed to be "weren't....

Typo... supposed to be "weren't....
Forum: Pontiac - Street 06-07-2026, 09:47 AM
Replies: 11
Views: 624
Posted By 78w72
More leaks at the rear of pan??? Did the builder...

More leaks at the rear of pan??? Did the builder at least run this for awhile to verify leaks etc?

I hate to sound like a broken record but what did they use for the rear oil pan U seal?? Same...
Forum: THE LOBBY 06-07-2026, 09:38 AM
Replies: 57
Views: 3,268
Posted By 78w72
At least you were another statistic like this...

At least you were another statistic like this poor lady....

https://www.foxnews.com/us/florida-woman-mauled-death-dogs-allegedly-terrorized-neighborhood-owner-charged-killing
Forum: 70-73 Firebird & TA TECH 06-02-2026, 09:46 AM
Replies: 2
Views: 276
Posted By 78w72
Stick with original mounts for the street IMO, ...

Stick with original mounts for the street IMO, if there is more power than stock, make your own "mighty-mount" out of stock mounts... Thats all they do, they grind the "made in taiwan" off stock...
Forum: Pontiac - Street 06-01-2026, 09:51 AM
Replies: 7
Views: 286
Posted By 78w72
Thats an older robbmc pump with the outlet on the...

Thats an older robbmc pump with the outlet on the underside, i have the same era but an 1100 model on my 467. Has been ran deadhead for 10+ years with no issues related to being set up deadhead. ...
Forum: 70-73 Firebird & TA TECH 05-25-2026, 09:51 AM
Replies: 7
Views: 656
Posted By 78w72
Thanks for clarification, i was thinking...

Thanks for clarification, i was thinking backwards... the vented cap allows air in to compensate for fuel being sucked out but doesnt allow air out to relieve pressure, thats what the added vent...
Forum: 70-73 Firebird & TA TECH 05-24-2026, 09:58 AM
Replies: 7
Views: 656
Posted By 78w72
My 72 had that EEC emission thing, I removed it...

My 72 had that EEC emission thing, I removed it and used a new non vented tank since I didnt want to run the lines and keep that, my other cars with the charcoal canister set up I eliminated too....
Forum: Pontiac - Street 05-09-2026, 09:26 AM
Replies: 12
Views: 239
Posted By 78w72
The blue car has the plastic valance that was...

The blue car has the plastic valance that was only available for a short time, then they went to the metal ones like the white car. They do look more unfinished than the plastic but are much...
Forum: 77-81 Firebird & Trans Am TECH 05-02-2026, 10:08 AM
Replies: 1
Views: 175
Posted By 78w72
Will the factory harness reach what? The 301...

Will the factory harness reach what? The 301 engine is in the same position and uses the same basic accessories as a 400 or 455, the harness should be the same length as other engines use.

For a...
Forum: Suspension TECH 04-15-2026, 10:23 AM
Replies: 2
Views: 262
Posted By 78w72
Do you have drums on front & rear? Basic...

Do you have drums on front & rear?

Basic adjustment for drums is to set the star wheel until the drum is just touching the shoes when installed, then back off just enough so it rotates without...
Forum: Pontiac - Street 04-15-2026, 09:58 AM
Replies: 8
Views: 343
Posted By 78w72
Im not 100% sure on this, but I recall Robbmc...

Im not 100% sure on this, but I recall Robbmc saying to not use a full return regulator with mech pumps, or that it will severely reduce the psi or flow ratings of the pump. What they recommend for...
Forum: Pontiac - Street 04-14-2026, 10:15 AM
Replies: 8
Views: 343
Posted By 78w72
With a Qjet that has the normal center inlet, I...

With a Qjet that has the normal center inlet, I just put my regulator a few inches away from the carb to clear the air cleaner. Its small and light enough that it works perfect with no bracket using...
Forum: Pontiac - Street 04-14-2026, 10:01 AM
Replies: 12
Views: 508
Posted By 78w72
Same process but I always used some grease.. then...

Same process but I always used some grease.. then make a sandwich with the bread! ;)
Forum: Pontiac - Street 04-14-2026, 09:58 AM
Replies: 78
Views: 4,385
Posted By 78w72
The secondaries in that pic definitely arent...

The secondaries in that pic definitely arent fully open... but they look to be at least 3/4 open and I doubt that is the cause of the low numbers. The internal set up/tune could be the cause.
...
Forum: Pontiac - Street 04-13-2026, 09:52 AM
Replies: 78
Views: 4,385
Posted By 78w72
Find a new builder/dyno... Something is way off...

Find a new builder/dyno... Something is way off for those numbers with that combo.
Forum: Pontiac - Street 04-12-2026, 10:01 AM
Replies: 24
Views: 834
Posted By 78w72
Dex3 is ideal, supertech make a good quality ATF...

Dex3 is ideal, supertech make a good quality ATF for best price, Ive been running that in a few vehicles for 20-30 years, high mile daily driver and pontiac t350/400s, have it in a TCI street...
Forum: Pontiac - Street 04-07-2026, 10:01 AM
Replies: 5
Views: 305
Posted By 78w72
Glad that info helps your decision. I was on the...

Glad that info helps your decision. I was on the fence about buying the VFN, I had a nice original hood with good corners and only a few small cracks in the vent slats but all were still intact &...
Forum: Pontiac - Street 04-06-2026, 10:13 AM
Replies: 5
Views: 305
Posted By 78w72
I have a VFN formula hood on my 72 firebird,...

I have a VFN formula hood on my 72 firebird, bought about 7-8 years ago, had to have the first one replaced by them due to some issue with the hood latch hole I will mention. Overall they are nice...
Forum: Performance Parts For Sale/Wanted 04-01-2026, 09:54 AM
Replies: 7
Views: 555
Posted By 78w72
Where are you located? Probably be easier to...

Where are you located? Probably be easier to post some basic info here vs posting your phone number and getting a ton of calls from tire kickers & repeating all the details to everyone...
Forum: Pontiac - Street 03-29-2026, 09:43 AM
Replies: 115
Views: 3,515
Posted By 78w72
I kept mine simple, just zip tied it to a factory...

I kept mine simple, just zip tied it to a factory bracket that is located towards the driver side of the car on the underside of the trunk area, pretty much the highest point in that area without...
Forum: Pontiac - Street 03-27-2026, 10:07 AM
Replies: 115
Views: 3,515
Posted By 78w72
HWY- Maybe the cars you used it on dont let it...

HWY- Maybe the cars you used it on dont let it be mounted high enough?

I can say for sure that after 10+ years I have zero slosh or spill over on my 72 firebird and thats with very hard...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 02:12 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017